Share waypoints between screens to be able to make a waypoint on structure on Fishfinder and have it pop up on other display.ģ. Get AIS info from VHF displayed on displaysĢ.

if either unit failed, I could swap the cables behind the dash to put the transducer or radar on the hopefully still good unit.ġ. Setup and Installation of NMEA 2000® Networks General Information The NMEA 2000 Network DeviceNet is the communication bus stan-dard developed by the National Marine Electronics Association (NMEA) for use in boats. The idea was Radar/GPS on one display, Fishfinder / GPS/ other stuff on second display. I realize that I can not put radar or Fish finder info on both displays as I purchased the slightly lower end line which does not allow sharing. I have included the motor but have no idea if there is a nmea2000 cable coming out of it or if a cable goes from the motor's electronics box to the suzuki gauge and then you tap into your network from there. NMEA 2000 network setup booklet, part number 988-0154-173, which. Connecting the above devices to the NMEA 2000® Trunk Line is a simple matter of adding a M12 T-connector at any point of the NMEA 2000® trunk line. Here's a rough drawing of the layout, VHF up high, 2 B&G 12' displays, Suzuki gauge (rebranded Navico) and motor. NMEA 2000 networking system developed by Lowrance Electronics. The two-channel interface is connected to the two CAN wires on the NMEA 2000® CAN bus via a specialized M12 to dual BNC connector supplied by Warwick Control. I am planning out the interconnects from my electronics and motor and would like a review of what I am thinking of doing by someone who has setup nmea2000 connectivity.

Nmea 2000 network setup